The selection of grease should pay attention to the following aspects: the use temperature of grease should be at least 50~60 degrees below its dropping point, which is conducive to the flexible change of grease varieties and meet the demand for different varieties of grease in different quantities.

The vast majority of the world's grease is produced by intermittent production process, electric injection molding machine grease such as equipment in the environment of the winter and summer Lee temperature changes, if the summer with the winter grease or the opposite, the results will be counterproductive. Pay attention to the regular replacement of grease, grease replacement time should be based on the specific use of the situation, both to ensure reliable lubrication and not to cause a waste of grease.

The grease should be stored in a cool, dry place and not in a wooden or paper container to prevent it from hardening, mixing with moisture or being contaminated.

The continuous process of grease production has only been used to a limited extent. Most of our grease production is also produced using the intermittent method production process, although the tube furnace production grease production process has a semi-continuous nature, in our grease production.

The lower fluidity of grease compared to lubricants makes it easier to adhere to parts, solving the problem of liquid lubricants not holding up on poorly sealed or unsealed parts. Electric injection moulding machine grease

Causes the grease to lose its consistency. The ideal high temperature resistant grease should have a small change in consistency after shearing, resulting in a long service life. The amount of lubrication to be filled should be appropriate. If the amount of grease is too large, the friction torque will increase, the temperature will rise and the grease consumption will increase; if the amount of grease is too small, it will not be able to obtain reliable lubrication and dry friction will occur. Generally speaking, the appropriate amount of grease is 1/3~1/2 of the total clearance volume in the bearing, but according to the specific situation.

As for the function, in addition to the basic lubrication, there are many functions such as sealing, heat dissipation, damping, rust and corrosion prevention, waterproof, anti-card bite and noise reduction.